step 1: preparing the materials
Prepare your work environment, by choosing the metal elements you want to us, and a colorful stones to your liking.
Cut all of the chain to this length:
Hexagon and round loops chain – two pieces of 18cm each.
Flat gourmet chain – 15cm
Big oval loops chain – 16.5cm
Small oval loops chain – 18cm
step 2: connecting the chains
The hexagon and round loops chain connect to the metal flower with a 5mm jump ring.
.jpg)
Use the plier tool to open and close the jump ring that hangs both oval loop chains together.
The laser cut center piece, the gourmet chain, and the two oval loops chains will hang by 5mm jump rings on the 6mm jump ring.
The metal flower connects to the 6mm jump ring with a 5mm jump ring.
Connect the three chains under the center piece, and the hexagon and round loops chain on both sides to close the necklace.
On one end of the necklace hang the clasp and on the other end hang a small piece of the same chain.
At the very end of the chain hang a swarovski crystal and a branded label.
Step 3 : setting the stones
Place the flower in the center of the stone setting and with the help of the setting tool bend the prongs until they close.
Bend the prongs gently to make sure you don't damage the stone or crack the plating in this process.
The small flowers needs to sit tightly in there place, so you will need to open the prongs a little before the flower can be placed in it's place.
Great!
The necklace is ready!
Enjoy your new beautiful Swarovski necklace.
Gita team.
